Top 10 Best Rule 1100 Automatic Bilge Pump

Completely automatic with manual override no float switch needed. Submersible and ignition protected. High efficiency, low amp motor. Stainless-steel shaft. Includes backflow preventer.

Non-automatic, used with a panel switch or Rule float switch. Submersible and ignition protected. Highly efficient, low amp motor. Stainless-steel shaft. Includes backflow preventer.

Bilge Pump 500. Power Rating 12V. Quick and easy installation. Refer to manufacturer recommendations and guidelines to ensure a proper fit.

3 Year Warranty.

Rule Mate 500 12 Volt.

3 Year Warranty.

Brand Rule Industries. Part Number 24DA-35A. 360 Bilge Pump With Switch. Non-Automatic, 12v with Rule-A-Matic Float Switch.

Reliably provides bilge water pumping for larger recreational boats. Meets automatic switch pump requirements for any vessels 20 feet and over with sleeping accommodations. High capacity for larger boats and yachts. Compact and durable package includes pump, wire seals, strainer, and mercury-free switch in one unit. Installs quickly and easily in tight spaces, mounts horizontally only. 12-volt, 1.5-amp draw pump is rated for 1100 GPH performance at open flow at voltage of 13.6 volts DC. Comes with a 29-inch length of 16-gauge caulked and tinned copper wire, and uses a 1-18-inch interior diameter hose.

Flow Rate GPH 1100GPH Volt 12V CurrentA 3.8A HeadM 3.0M. Wire LeadM 1m Outlet Diameter 29mm 1.14 Inch 1-18 Width Approx. 81mm. Built-in float switch No separate float switch is needed. No power use until pump is activated by internal float switch when water level rises. Equipped with built in electronic controlled reed sensor system for easy fully automatic operation.

A genuine Rule pump, 3 year warranty. Electronic sensing series bilge pumps. Turns the pump impeller every 2-12 minutes for approximately one second. If water is present, the pump will sense resistance and will continue to run until all water is removed. A compact way of constantly sensing for water presence.