Top 10 Best Sdfsdretsdfsdf

Premium RTL-SDR bundle includes NESDR SMArt XTR in beautiful brushed aluminum enclosure, re-designed antenna base with 2m 6.5' RG-58 feed cable, and 3 antenna masts. A wide variety of improvements on other designs, including ultra-low phase noise 0.5PPM TCXO, 2 separate RF-suitable voltage regulators, custom heatsink, 2 silicone pads and SMA female connector. Designed from the ground up to reduce USB port occlusion. Run multiple NESDR SMArt series devices side-by-side with any USB-compliant device, including tightly-spaced embedded devices like the Raspberry Pi. SDR frequency capability approximately 65MHz-2300MHz. Frequency range can be extended down to 100kHz or lower with the Ham It Up, also available on Amazon B009LQT3G6. Proudly built by Nooelec in the USA and Canada Full 2-year product warranty.

Included RTL2832U and R820T tuner ICs on the USB device. Nooelec guarantees a protection diode on the input to protect from ESD damage. Compatible with most SDR software, including SDR. Provides an approximate tuning range of 27MHz-1700MHz for software defined radio SDR. Includes Nooelec USB SDR and antenna. Full 1-year warranty against manufacturer's defects.

Includes 1x RTL-SDR Blog brand R860 RTL2832U 1PPM TCXO HF Bias Tee SMA Dongle V3 Dongle Only. Several improvements over other brands including use of the R860 tuner, improved component tolerances, a 1 PPM temperature compensated oscillator TCXO, SMA F connector, aluminum shielded case with thermal pad for passive cooling, and an activatable bias tee circuit.. Can tune from 500 kHz to 1.7 GHz and has up to 3.2 MHz of instantaneous bandwidth 2.4 MHz stable. HF reception below 24 MHz in direct sampling mode with reduced performance. Please note RTL-SDR dongles are RX only..

A full, wide-band RF solution for those interested in getting started with software defined radio and with a keen interest in HF bands. Frequency range is 100kHz-1.7GHz with a frequency gap near 1.1GHz. The NESDR SMArt XTR HF Bundle utilizes a well-designed upconverter--the Ham It Up Plus--to receive HF, instead of utilizing a direct sampling hack as with most other low cost HF SDRs. This results in a vastly different HF experience--much better performance, and no loss of gain controls. Included is a Ham It Up Plus upconverter, installed in a custom silver aluminum enclosure with fully build noise source circuit an NESDR SMArt XTR RTL-SDR, 3 antennas, an impedance matching balun for longwire and dipole antennas, and interconnect adapters and cables. Amazon-exclusive bundle Only available for a limited time. Due to the frequency gap this is NOT recommended for ADS-B. Instead try our NESDR SMArt HF Bundle Amazon product code B0747PX3NZ.

Frequency range of 50 MHz to 4000 MHz. Noise figure 0.6dB 900 MHz. OIP3 39.5 dBm 900 MHz, P1 Saturation 22.7 dBm 1960 MHz. Gain 18.7 dB 900 MHz. Bias Tee Powered Needs 3-5v bias tee power.

Turn your computer, phone or tablet into a radio scannerham radio receiver that can receive nearly all RF signals Compatible with Windows, Mac OS, Linux, and Android. NESDR SMArt RTL-SDR v5 can be used for the reception of broadcast AM radio, broadcast FM radio, shortwave radio, CB radio, public security radio, trunked radio, air traffic control, ACARS plane-ground communications, ADS-B plane tracking, AIS ship tracking, POCSAG pagers, NOAA and GOES weather satellites weather images, weather balloons, radiosondes, DAB radio, DVB-T video, Inmarsat, Iridium, and so much more. The best-performing low-cost RTL-SDR available anywhere Compared with RTL-SDR v3, HF SNR is improved by up to 15dB, VHF UHF SNR is improved by up to 6dB, tuning accuracy is improved by an average of 4x, and the frequency range is expanded all the way down to 100kHz. v5 has a frequency capability of 100kHz to 1.75GHz and up to 3.2MHz of instantaneous bandwidth. HF reception below 25MHz is accomplished with direct sampling and requires a suitable antenna. We recommend using a Balun One Nine to make a DIY long wire or dipole antenna sold separately, product ID B08HGSYB7R or B00R09WHT6. Though the direct sampling implementation of NESDR SMArt v5 is much better than any other RTL-SDR, we still recommend using an upconverter like the Ham It Up for a more fulfilling HF experience sold separately, product ID B076CYK8XZ. Your purchase includes a NESDR SMArt v5 RTL-SDR. For a version which includes an antenna set, see product ID B01GDN1T4S. Proudly built by Nooelec in the USA and Canada Full 2-year product warranty and product support through our support portal at httpssupport.nooelec.com. Full datasheet available httpswww.nooelec.comdatasheets100701.

Turn your computer, phone or tablet into a radio scannerham radio receiver that can receive nearly all RF signals Compatible with Windows, Mac OS, Linux, and Android. NESDR SMArt RTL-SDR v5 can be used for the reception of broadcast AM radio, broadcast FM radio, shortwave radio, CB radio, public security radio, trunked radio, air traffic control, ACARS plane-ground communications, ADS-B plane tracking, AIS ship tracking, POCSAG pagers, NOAA and GOES weather satellites weather images, weather balloons, radiosondes, DAB radio, DVB-T video, Inmarsat, Iridium, and so much more. The best-performing low-cost RTL-SDR available anywhere Compared with RTL-SDR v3, HF SNR is improved by up to 15dB, VHF UHF SNR is improved by up to 6dB, tuning accuracy is improved by an average of 4x, and the frequency range is expanded all the way down to 100kHz. v5 has a frequency capability of 100kHz to 1.75GHz and up to 3.2MHz of instantaneous bandwidth. HF reception below 25MHz is accomplished with direct sampling and requires a suitable antenna. We recommend using a Balun One Nine to make a DIY long wire or dipole antenna sold separately, product ID B08HGSYB7R or B00R09WHT6. Though the direct sampling implementation of NESDR SMArt v5 is much better than any other RTL-SDR, we still recommend using an upconverter like the Ham It Up for a more fulfilling HF experience sold separately, product ID B076CYK8XZ. Your purchase includes a NESDR SMArt v5 RTL-SDR, a magnetic antenna base with a 2m 6.5' RG-58 feed cable, and 3 different antenna masts for UHF and VHF operation, including a variable-frequency telescopic antenna. Proudly built by Nooelec in the USA and Canada Full 2-year product warranty and product support through our support portal at httpssupport.nooelec.com. Full datasheet available httpswww.nooelec.comdatasheets100700.

Includes all hardware and software free download you need to get started with software defined radio. Listen and see nearly any RF signal within the frequency capability of the radio 27-1700MHz. Included is an NESDR SMArt v4 RTL-SDR, 3 antennas, a Flamingo FM broadcast FM bandstop filter, 10 RF adapters and cables, and a carrying case. Proudly manufactured by Nooelec in the USA and Canada, with a full 2 year product warranty on all bundle components and 247 technical support availability. Please contact our support team any time if you have questions. Amazon-exclusive bundle Only available for a limited time.

Premium software defined radio NESDR SMArt XTR in a beautiful silver brushed aluminum enclosure. A wide variety of improvements on other designs, including ultra-low phase noise 0.5PPM TCXO, 2 RF-suitable voltage regulators, custom heatsink, 2 silicone pads and SMA female connector. Designed from the ground up to reduce USB port occlusion. Run multiple NESDR SMArt series devices side-by-side with any USB-compliant device, including tightly-spaced embedded devices like the Raspberry Pi. SDR frequency capability approximately 65MHz-2300MHz. Frequency range can be extended down to 100kHz or lower with the Ham It Up, also available on Amazon B009LQT3G6. Proudly built by NooElec in the USA and Canada Full 2-year product warranty..

A full, wide-band RF solution for those interested in getting started with software defined radio and with a keen interest in HF bands. The NESDR SMArt HF Bundle utilizes a well-designed upconverter--the Ham It Up--to receive HF, NOT direct sampling hacks. This results in a vastly different HF experience--much better performance, and no loss of gain controls. Included is a Ham It Up v1.3 upconverter, installed in a custom black aluminum enclosure an NESDR SMArt RTL-SDR, 3 antennas, an impedance matching balun for longwire and dipole antennas, and interconnect adapters. Proudly manufactured by Nooelec in the USA and Canada, with a full 2 year product warranty on all bundle components and 247 technical support availability. Please contact our support team any time if you have questions. Amazon-exclusive bundle Only available for a limited time. NOTE enclosure colors may vary contingent on availability.